sickbeard + nzbget issues

[Lacroix]

I'm trying to install and setup sickbeard and nzbget on my a300, but am running into issues.

By default, nzbget 0.6 is installed on the pch, correct?
Then I installed "local 0.1.8", and "sickbeard 1.0" using the CSI.
After this I set up both sickbeard and nzbget 0.6.

Then I added shows to sickbeard and sickbeard would send the nzb to nzbget, here I would get error messages.

In sickbeard: "NZBget could not add to the queue"
In nzbget 0.6: "error parsing nzb", and no further info

After searching a bit on google, I read that the parsing errors should be gone in a further version of nzbget, so I installed "nzbget 0.8-testing".

Afer this, sickbeard could succesfully send nzb's to nzbget, however I would receive a connection timeout from my newsserver.

When I had installed nzbget 0.6, I setup my newsserver correctly and testing this by uploading an nzbfile.
After upgrading to nzbget 0.8, the settings would still be the same, however when I upload an nzb file, I get the same connection timeout.
The error says my newsserver is "my1.newsserver.com", but my settings page tells me I have setup the correct one. (only 1 server).

Then, when I try to set the newsserver again, in nzbget 0.8, and restart after saving my changes, by nzbget version is back to 0.6, so I get the parsing error again.

Can someone tell me what I'm doing wrong?