No activity (powerled is burning, IDE+network are not flashing)

[Tijmenteloo]

The first problem was that the lights on the front are not burning.
After a few restarts this problem is solved. But now the pch will start-up (you hear the HDD spinning) But there is no activity on the tv. The HDD led is no flashing and the network activity lights on the back are not flashing or burning. I can't see any thing on tv. also when I start up without HDD.

Does anybody know what this could be ??

[q2no]

How is your TV connected to the PHC?
Try composite (yellow connection on the tv and PHC) and on hit on the remote TV-mode... wait 2 seconds... and then 2, for composite screen..
Make sure that all your other TV signal cables from the PCH towards the TV are disconnected(exept for the composite)

[cmgrant]

This seems to be similar to the problem I am having. If you do manage to get it to composite mode let me know if you get a green screen.

See here

http://www.networkedmediatank.com/showth...?tid=18732

I also have a email into support.
cmgrant

[Tijmenteloo]

(03-10-2009 07:41 PM)q2no Wrote:  How is your TV connected to the PHC?
Try composite (yellow connection on the tv and PHC) and on hit on the remote TV-mode... wait 2 seconds... and then 2, for composite screen..
Make sure that all your other TV signal cables from the PCH towards the TV are disconnected(exept for the composite)

I normaly use HDMI 1080p@60Hz.
But I don't understand how I should test? I have now connected pch only with component (yellow) cable to my tv. When i put in my powerplug the front leds wil burn. Then I push TV-mode on my remote, but nothing happends. also when I touch "2" after two seconds nothing is happen. I try this with and without my HDD attached. Do I something wrong ?

[Tijmenteloo]

Solved, by ordered a new PCH !